For all Fallout fans, have a little bit of Vault-Tec right on your desk. This cellphone dock is designed to be printed without any supports. It is three pieces, the back has rails and the Vault-Tec badge on the front has holes to take really short nibs of 1.75mm filament. All you have to do is print, do a little clean up on the parts if your printer leaves any little artifacts and assemble. I would recommend gluing the Vault-Tec badge though. Also, I have considered scaling it up about 10%
Print Settings
Printer Brand:
RepRap
Printer:
Prusa i3
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
30
Credits:
Walter_B