This is a compact camera grip that I made since I wanted a small grip I could maybe use with my phone when filming. I looked on Thingiverse for Grips and Tripods but couldn’t find anything that didn’t require extra screws, nuts, bolts, tools, etc. So I just went in Fusion 360 and made my own Grip.
Instructions:
Step 1: You will first need to print one of each part. There are five parts. Make sure to print Main Screw at 101-102 percent scale (Not required though recommended by me).
Step 2: For this step you will need some super glue, this is probably the most important part. First you will need to take the Main Screw Enclosure, Main Screw, and the Pivot Point. With the Main screw sticking out the top of the Main Screw Enclosure, glue the bottom of the Main screw enclosure to the top (Flat Side) of the Pivot point.
Step 3: Take the handle and insert it between the legs of the Pivot Point.
Step 4: Now take the Pivot Point Screw and insert it. Make sure that the threaded side of the pivot point is opposite of the screw.
Read: I would highly recommend that you only use a phone with a selfie stick smartphone holder instead of a heavier camera since the screw is only made out of plastic and can easily break and get stuck in the camera.
Other: At the bottom of the handle is a threaded hole. This is there so that in the future I can make some attachments that can attach to the bottom of the handle. If you would like you can make attachments for it! The screw is a 10 mm (Diamenter), M10x1.5 screw. Depth of 15 mm.
Print Settings
Printer:
MP Mini Delta
Rafts:
Doesn’t Matter
Supports:
Doesn’t Matter
Resolution:
0.2 mm
Infill:
35% (100% on Screws)
Notes:
Also, don’t hesitate to post your makes!
Credits:
Michael_JM
Download 3D models
| File | File size |
|---|---|
Fully_3D_Printed_Compact_Camera_Grip
|
936 KB |