Wanted:
A base to hold my GoPro on a shelf, table, dash board, stabilize it in the sand, have it float upside down in the water and still look kinda edgy but cool just sitting on display. Hence the design. Beveled edge, odd number of sides, approximately 1″ in height (perfect for sitting next to my Mono Price Mini Delta for recording prints).
NOTE: Working on trying to fix the .STL, the Z attribute is off and causing the print to float in mid air
Print Settings
Printer:
MonoPrice Mini Delta
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
20%non-float/80%float
Notes:
Quite basic but it performs well. Slight sanding may be required on the center pin inside the latch.
Credits:
JME3D