External dimensions, W-220mm, L-205mm, H-125mm
Internal dimensions, W-195mm, L-155mm, H-115mm
Print the clips with PETG@100% infill.
You must use the TPU seal if you require your case to be water resistant and dust proof. Print the seal with 2 perimeters and 0% infill, this is important because you want your seal to be squishy for a good seal and also for your lid to close properly. When placing into the groove of the bottom of the case, make sure the flat part of the seal is facing up towards the lid.
Alternatively you can purchase 3mm round seal from most hardware stores and cut to length and superglue in the groove provided.
You will require 8 M3x40mm fasteners, they all screw into the plastic.
Optional 8—–8x3mm neodymium magnets for the top tray and top tray lid.
There are access holes for the handle fasteners just below the clip fasteners of the case. I’ve included optional hole caps if you want to cover up the access holes after the handle has been installed, as shown in the photo description, the caps are in red.
I designed this entire case to be printed on a Prusa MK3/Ender 3 size printer.
No supports are needed.
Credits:
muddymaker
Download 3D models
| File | File size |
|---|---|
gorilla-space-case-water-resistant-dust-proof-and-lockable-model_files
|
960 KB |