Gyroid Infill Orchid Pot

Gyroid Infill Orchid Pot

This is a two-textured pot made up of two intersecting models: a model for the top, bottom and spiral stripes which I printed with side perimeters, and a model for the sweeping sides of the pot, which I printed with gyroid infill but no perimeters. This allows you to have a two textured pot without MMU.

I printed my model in translucent PLA, and the sides are 10% infill gyroid pattern, though you could play with different settings for a different look.

Credits:

ZAdventurer

Rate this 3D model

Leave a Reply

Your email address will not be published. Required fields are marked *