This is a headphone holder for a microphone stand with a beam width of 10mm, It requires one 3mm hole to be drilled in the microphone mount, however most seem to with a hole preinstalled.
Additional hardware needed:
2x M3-20 screws
2x M3-0.50 nuts
the forward screw is to put through the through hole, the rear screw is to clamp over the beam in order to clamp the holder at the proper angle.
Print Settings
Printer brand: Creality
Printer: Ender 3
Rafts: No
Supports: No
Resolution: 200
Infill: 20
Filament brand: 3dfuel
Filament color: brown
Filament material: Recycled PLA
Credits:
blah42