A huge beautiful looking case for you Raspberry Pi 3b+
To print this beast you need around 30-40 hours depending on your printer.
What you need to print:
1x front
1x back
3x connectors
What you need to assemble it:
3x bigger screws to screw together the back and front part
2x small screws for inside the case (hold raspberry pi in place)
some superglue
and most importantly you need every cable (micro usb, hdmi, ethernet, usb) in low profile or you risk to not have enough space in the case!
How to assemble:
Glue the three connectors in either the top or back part
Mount Raspberry Pi and do your cable management
Stick front and back together and use the 3 screws (cut the connector a little if needed)
Done. Now look awesome 🙂
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
Yes
Infill:
10%
Notes:
You only need supports with the back part. Infill 10% is more than enough. You need around 300-400m of pla
Credits:
jor_93