I remixed this because I couldn’t find one for my 12.9″ ipad and needed one. The original design was fine but just didn’t fit the new ipads. The bracket works very well as originally designed. I elongated the holes when resizing it which allows for leveling the bracket if your screws are not perfectly plumb. You may want to adjust the height and/or width to fit your particular ipad if not the standard 12.9 current (2017/8) model.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
Yes
Resolution:
Draft
Infill:
25%
Notes:
Print a .8 floor and walls for strength and ease in removing print. You need supports for the 4 overhanging components but a small zig-zag works fine. I only used a 25% infill for rigidity and durability over the long use but a higher level is not necessary.
Credits:
tswalter