This dock is designed for the iPhone 6, 6s and 7. The original lightning cable fits inside the dock so you can charge your phone with it. The two holes in the front are for the speaker and microphone.
The iPhone 7 just fits in the 6 and 6s dock, but the cable actually doesn’t. The cable is a bit thicker. So there is a modified dock for the iPhone 7 cable.
Print Settings
Printer Brand:
RepRap
Printer:
Sunhokey Prusa i3
Rafts:
Doesn’t Matter
Supports:
No
Resolution:
0.2 mm
Infill:
30%
Post-Printing
I used micro suction tape on the bottom of the dock, so it sticks to the surface you put it on. So you can take the phone out without holding the dock. Double sided tape should also work.
Credits:
TSBK92