Lenses on VR equipment are very sensitive to sunlight, and the Oculus Go headset does not come with a cover or case so I designed a fitted protector for the lenses and also incorporated a holder for the controller. Designed in 2 pieces so it can be printed flat, the controller holder snaps into the hole and is rotatable, it’s a little tight but it will fit and I didn’t want it to freely rotate.
There is a 2nd version of the cover without the logo and the controller hole moved to the center, in case you would prefer that one.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
No
Supports:
Yes
Resolution:
.3mm
Infill:
5%
Notes:
Supports on the controller holder depending on orientation, no supports needed for the protector itself if printed face down (nose piece up). Printed with Ziro Marble 1.75mm PLA.
Credits:
Chimaera