A speaker mount for a horizontal alignment of 2 logitech speakers from a 5.1 set. One holder combines a front and a rear speaker, for positioning the speakers on the desk when used as 2.1 system. A slim horizontal design of te mount allows placing the spekers under the displays of a multi monitor setup.
The mount uses the original screws, so that nothing than the printed mount is needed.
I printed with 2.4mm layerheight, however a lower one would produce nicer results (or just sand them afterwards).
With the 25% infill and the 3 wall lines I used, the mount is not super stable, but strong enough to hold the speakers with ease.
Print Settings
Printer:
Anet A8
Rafts:
Doesn’t Matter
Supports:
Doesn’t Matter
Resolution:
2.4mm –
Infill:
25% +
Notes:
Wall line count: 3 +
Credits:
934750436