Here is a muti-piece Minecraft ore block I made. The pieces fit together fairly tightly so you shouldn’t need to glue it or anything.
The block stand is mainly in case you want to add a light into the block and it’s too high up. If you use the stand the light sits lower and looks better depending on your light fixture. I bought 5 2.75″ light pucks for about $15, but any light you can fit in there should work fine.
Print Settings
Printer: Ender 5 Pro
Rafts: Doesn’t Matter
Supports: No
Resolution: 0.2mm
Infill: 20
Filament brand: HatchBox
Filament material: PLA
Notes:
For printing be sure to print all 4 walls facing down the same way, otherwise the outside won’t look as good. The top part can be flipped either way.
In the pictures I printed my block 75mm x 75mm (2.95″).
To make the block you will need:
4x Ore_Wall
1x Ore_Top
Optional:
Ore_Stand to put the block on top of and provide extra room for a light
Ore_Wall_With_Wire_Slot replace one of the Ore_Wall’s if you want to use a light with corded power instead of batteries
Credits:
Minecraft Ore Block Lamp