Mod / remix for the top section of the Noyce prints headphone stand …
I liked the original stand but had reservations about the top section, I then saw and liked the remix from ZoltanKi… but the sides were too large for my build plate … so I decided to make a set of “arms” to fit the original headphone stand and use the coloured “bridge section” from ZoltanKi’s remix (his “bridge piece” is included as a download here for simplicity and just in case ZoltanKi changes or removes the original file)
You will need 4x extra M3x100mm screws to attach the “bridge piece”
This mod can easily be retro-fitted to original Noyce prints headphone stand if you have already built that.
For “completeness” I also used the “M3 decorative washers”
Thanks to all for sharing … and if anyone wants want to tip me to buy me a coffee (or gin) for my efforts, its always nice to be appreciated.
Print Settings
Printer brand: Creality
Printer: Ender 3 Pro
Rafts: No
Supports: Yes
Resolution: 0.24
Infill: 40%
Filament_brand: Prusament/Eryone
Filament_color: Orange/Green Black
Filament_material: PETG
Notes:
“Supports on build plate only” for arms … I placed them with the outside face down so that any rough faces from supports are easily hidden when you screw them in to place.
Higher resolution / slower prints will obvs make your prints prettier – but at 0.24 looks good on desk and was a trade off between print time and quality (photos exaggerate rough edges)
Credits:
damnit72
Download 3D models
| File | File size |
|---|---|
Modded+top+section+for+ Headphone+stand+(setup+themed)
|
1 MB |