I wanted a Nintendo Switch stand that would be stable, pocketable & allow to charge the console.
The display angle can be adjusted, it stores 8 games in its base & fold in your pocket.
Designed with the 3D printing constraint in mind, this stand is printed in one piece without any support.
I’ve been using mine for several months now and it’s very sturdy.
I was afraid the hinges would fail but they hold up pretty well.
Let me know what you think or what can of improvement could made in the comment section.
Print Settings
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: No
Supports: No
Resolution: 0.2
Infill: 20
Filament: Ariane Plast PLA Gun
Notes:
Print as it is, lay it flat on your bed and press print.
Make sure your bed adhesion is ok & crank up your ventilation to the max (there are tiny bridges in the hinges).
Tolerance are around 0.3 so it should be alright for most printer out there.
Credits:
Qaz3D