Oculus Quest External Battery Mount

Oculus Quest External Battery Mount

Oculus Quest External Battery Mount

Oculus Quest External Battery Mount

External battery holder for Oculus Quest, specifically designed for an Okzu 10000mAh USB C Power Bank. Clips to the lower rear horizontal-ish strap on the Oculus Quest headband.

Using a USB-C to USB-C cable, this power bank seems to be able to keep up with the full power demands of the Quest, slowly recharging even while the headset is being actively used.

The slot for the headband is a very tight fit — you may want to sand it open a bit, but I erred on the side of increased security because I do not want to launch a battery across the room. It also wouldn’t hurt to add a velcro strap around the whole thing if you’re a belt-and-suspenders type.

Regarding cable length: I have found a 1-foot right angle USB-C to USB-C cable to be perhaps an inch short of perfect, but I have a big head.YMMV.

Finally, please decide for yourself if you really should hang a flammable hunk of lithium on the back of your skull using a homemade plastic gizmo. It’s probably a terrible idea, and I certainly don’t recommend it. Best case, it could tear the cable out of your expensive VR toy and send a projectile across the room; worst case, you could do a remarkable live impression of Ghost Rider. Caveat factorem.

Print Settings

Printer: Monoprice Mini

Rafts: No

Supports: No

Resolution: .2188mm

Infill: 20

Filament: generic PLA purple (it’s what I had)

Notes:

Tip: as long as it’s rotated on the print bed like it is in picture #2 it doesn’t need any support.

Credits:

belllsy

Rate this 3D model

Download 3D models

File File size
zip Oculus_Quest_External_Battery_Mount 777 KB

Leave a Reply

Your email address will not be published. Required fields are marked *