Phone holder and magnetic connector charger

Phone holder and magnetic connector charger

I made for my daughters a phone holder with a charging base with a wire and a magnetic connector. I used this wire which is available with the connector for iPhones and other phones with USB connectors.

The two supports were made on a special occasion and bear the names of my daughters; the file I am attaching is neutral, without names.

The tail file is common for all versions, while the body is available neutral, with the bass or with the dancer. The tail, in addition to holding everything, blocks the cable and allows it to come out from the left or right.

Print body on the back without supports and tail in the final position. The ballerina and the bass were filled with paint.
Hope you like it, let me know!

ASSEMBLY
1) Mount the magnetic connector on the phone and place the phone on the support;
2) insert the cable from underneath into the hole up to the magnetic coupling;
3) bend the cable 90 ° and partially insert the tail;
4) orient the cable to the right or left and complete the insertion of the tail.
That’s all!

Print Settings

Rafts: No
Supports: No
Resolution: 0.20
Infill: 20
Filament_brand: No brand
Filament_color: As you want
Filament_material: I used PLA

Credits:

ThorLAB

Rate this 3D model

Download 3D models

FileFile size
zip Phone+holder+and+magnetic+connector+charger4 MB

Leave a Reply

Your email address will not be published.