Phone holder Phone stand

Phone holder Phone stand

Phone holder Phone stand

Phone holder Phone stand

A seamless phone/ipad stand. It takes 1 h 40 min to print. No overhang, NO sharp edges, No support, YES YES YES.

Here, I round all the edges in the redesign that will be safe for my 2 years old son. Most importantly, I design it in a way that the holder can print on the side, so that there is no more overhang issue at all and the beautiful curvature in the design can be achieved nicely in the print.

Use this for printing and print as it is.

This is for the purpose of modification. Just in case you want to add a logo on the back of the stand. The angle of two plates are 40°

Gcode is often shared here. The part is located in the center, Prusament PLA, Prusa MK3, 20% infill, no rafts, no supports.

Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: No

Infill: 20%

Filament: Prusament PLA AZURE blue



Rate this 3D model

Download 3D models

File File size
zip Phone holder Phone stand 768 KB

Leave a Reply

Your email address will not be published. Required fields are marked *