Folding phone stand with built in hinge. I had a special request by my significant other and since it was near valentines day… I had to oblige. The angle and overall design was created by that feedback so if you don’t like the angle… It isn’t my fault :).
The entire stand is printed at once in place.
Print Settings
Rafts: Doesn’t Matter
Supports: No
Resolution: 0.2
Infill: 100% hinge area, 20% everywhere else
Filament: eSun PLA Black
Notes:
You can use your slicer’s infill override to have the hinge area at 100% infill and the rest only 20% infill or just make it simple and print it 100% infill. It doesn’t use up a lot of PLA. The hinge area should be 100% though for best strength.
Credits:
agibson2