A complete new design case for the Raspberry Pi Camera 2.1.
This has a snap together case with ball mount to allow it to be adjust in different angles. The design has a flat mount and a corner mount.
When inserting the ball into the mount, it will be tight. If the mount breaks then try scaling the mount slightly bigger.
I printed mine in fine mode to give the ball a smoother surface to allow better adjusting of the camera.
Attach cable to camera
Place camera in front cover on alignment pins
Install back cover straight down. Use a pair of pliers to open the opposing keeper.
Print Settings
Printer Brand:
PowerSpec
Printer:
PowerSpec 3D Pro
Rafts:
No
Supports:
Yes
Resolution:
Fine 0.1
Infill:
80%
Notes:
Depending on printer model and setting you may need to scale the mounts to get the best fit if it seems loose. You can also use a small piece of tape on the ball to fill the gap.
Credits:
TraylorHead