This tiny subwoofer reaches very low for its size, 45Hz. It does this by using a 3D printed passive radiator. Check out the video:
The passive radiator surround must be printed with flexible filament.
At 180x115x106mm, it will print on almost any printer and only uses ~600g of filament.
It is designed specifically for the Tang Band W3-1876S driver, (the same one used in Hexibase’s Hexibox subwoofers). A word of warning: due to the low tuning frequency, and the mass of the passive radiator, this speaker puts out a lot of vibration. You will need somewhere stable to put it and will likely need to bluetack it down!
If you are not down with flexible filaments, I have also included a version of the enclosure which will work with a Peerless P830878 passive radiator. Fusion 360 and STEP files provided for anyone who wants to hack about.
Someone will ask the inevitable question; is this better than the Hexibox using the same driver? It isn’t better, but it is comparable, and it is half the size and uses less than half as much filament. On top of that, it’s got a 3D printed passive radiator, how cool is that? Print both and compare.
Print enclosure with 3 walls and >40% infill.
When printing the surround, turn on “detect thin walls”, and/or set extrusion width to 0.4mm.
Parts and Assembly
Source the driver:
USA: https://www.parts-express.com/Tang-Band-W3-1876S-3-Mini-Subwoofer-264-909
Europe: https://www.soundimports.eu/en/tang-band-tang-band-w3-1876s.html
Other items:
8 x M3 Screws
Glue (I recommend epoxy for the brace and front panel and clear gorilla glue for the flexible surround.)
Bluetack
During Assembly, it is very important to get good seals on all the joints, any leaks will significantly reduce the efficiency and the bass response.
Assembly Process:
Glue the Brace into place and secure with screws
Glue wire the cable into place and carefully seal the channel from the inside
Glue the front panel into the enclosure
Glue the center piece of the passive radiator to the surround, using the jig to clamp it
Glue approximately ~30g of mass into the cavity center piece
Glue the surround into the enclosure, using the jig to clamp it
Fit the driver, making a gasket out of bluetack
Measure the impedance to find the tuning frequency, b y looking for the dip, (see images)
Add additional mass 10g at a time, untill the tuning frequency is between 50 and 55Hz.
Enjoy
Credits:
zx82net
Download 3D models
| File | File size |
|---|---|
PPR+Mini+Sub-Woofer+with+Printed+Passive+Radiator
|
6 MB |