There are a lot of designs for phone stands on this website, but most of them are more used to view the phone, rather than take videos with it.
This stand can do BOTH. It can hold a phone for you to watch a movie with, or it can be used to take videos (both in the vertical and horizontal orientation), while also allowing to switch between 3 possible angles, by inserting the phone in the different ridges on the base.
This phone stand is super easy to print. I used PETG, but you can of course use PLA as well.
Note: I didn’t use support, however there is a little overhang at the end. It should not be a problem unless your printer is really bad, but anyway I have also included a version without the holes (they were there to reduce the material amount), if you prefer to use that (or use support otherwise if you don’t trust your overhangs!).
Have fun with it, and if you decide to print it please post your make! 🙂
Print Settings
Printer brand: Creality
Printer: Ender 3 Pro
Rafts: Doesn’t Matter
Supports: Doesn’t Matter
Resolution: 0.2
Infill: 30%
Filament brand: Eryone
Filament color: Red
Filament material: PETG
Credits:
andratos95