I needed a quick couple of SD card cases the other day and downloaded/printed Rod’s SD Card Holder remix of guytas’s SD card labelling case – both are great models.
However, I was looking for something a little bit smaller. Although from scratch, I used Rod’s model as a guide to generate my model, which nicely secures the SD card w/ a printed spring. In my model’s case, the label is much smaller – only the width of the card, but it protects the card nicely and securely and allows for a nice short label.
I printed in PLA, .2mm layer height, 20% infill. Uses .825 meters of filament.
Credits:
Nem
