Here is a stackable HDD case, suitable for 2,5” hard drives, (12mm thickness or less).
No screws needed, each hard drive stays in place due to the friction with case walls.
I uploaded the original FreeCAD file, feel free to improve the design !
I just stacked 3 of them, I’m sure you can stack 2 or 3 cases more, with the applied offset. The offset make it easier the SATA-to-USB bridge I use to connect the hard drives.
Even if FreeCAD is a good parametric 3D software design, I had to repair the final model (Mesh mode in FreeCAD). STL file repaired provided.
Print Settings
Printer brand: XYZprinting
Printer: da Vinci Jr. 2.0 Mix
Rafts: No
Supports: No
Resolution: 0.2
Infill: 30%
Filament_brand: xyzPrinting
Filament_color: Orange
Filament_material: ABS
Notes:
Printed with Da Vinci 2.0 Duo, bed required, setup “Good”, all print settings by default.
Credits:
martee