This is a threaded micro SD and SDHC card holder.
I was looking around for a micro SD card and regular SD card holder to store my camera sd cards (I have two which use different sized cards) But I couldn’t find a holder that either had a lid which would keep them together when travelling, or had slots for both types of card rather than one or the other. So I came across the two holders from n2b8 and bgill, which then gave me the idea to combine the two. please note the threads are a little tight and will need wearing in a bit, I did this by just twisting several times then ( or opening and closing it) but do this gradually as I found with PLA it fractured on the first time. once the threads have been worn in make sure to clean them as PLA dust can build up.
Print Settings
Printer:
CTC Bizer
Rafts:
Doesn’t Matter
Supports:
No
Resolution:
0.2mm
Infill:
20%
Notes:
both files can be printed without supports as the fillets on them both aren’t big enough over hangs to be an issue and a raft is also not necessary.
Credits:
Ryan_Payne