Note: Added a Rev1 this has a different shape, It’s up to you to decide! Which one, you want to glue into the wall holder.
CAD MODEL IS INCLUDED!
Glueless version:
Use the anvil to tap the V-shape in place with a few gentle taps with a hammer.
Mounting to the wall with double-sided tape or screws (holes not included requires 100% infill)
3D printing settings
PLA/PETG
Hotend 200/240
Bed 45/60 (3Dlack)
No supports
Fan 100%/60%
Print the part that sticks to the wall on its side
Print the V-Shape part with the bevel up so no overhangs are created that way.
Note: in order to get the part closed you need to set the infill line direction to 115,205 degrees else the bridging could not end up as nice as possible
[spoiler title=”Changelog:”][/spoiler]
Credits:
PattysLab