++Update 2017-09-25++
Made the distance piece a little thicker. Now it equals the Wall Mount.
Introduction
I needed a Wall Mount for my 7″ Tablet running Home Assistant. The problem was that i could not drill holes into the wall where i wanted the tablet becaus auf electric wires running there.
I wanted something invisible.
Use TESA Double sided Tape (i used 55740) or similar to glue the parts on the Wall and on the tablet.
You can print as much distance pieces and rails as you need since the design is universal it will always fit.
Print Settings
Printer:
Anet A8
Rafts:
Yes
Supports:
No
Notes:
Print slightly slower and make sure you retreat the filament otherwise you will get small strings between the walls.
Credits:
rreinhard