Headphone holder insertable in an Ikea Kallax corner

Headphone holder insertable in an Ikea Kallax corner

Headphone holder insertable in an Ikea Kallax corner

Headphone holder insertable in an Ikea Kallax corner

This headphone hanger differs from other hangers because it can be clamped into a interstice between two adjacent corner elements. Secured without damaging anything.

If your headphone is lightweight, you’ll be fine with only the hanger itself. If your headphone is heavier, insert the vertical support rod to prevent bending (and eventual breaking) of the thin plate.

Print Settings

Printer:

Anycubic I3 Mega

Rafts:

Doesn’t Matter

Supports:

Yes

Resolution:

0.2

Filament: cheap PLA

Post-Printing

Release the corner elements with a hex key, insert the hanger and fasten them again.

Credits:

I used the design of the joint from Mounting elements for IKEA’s STUGVIK shower rack
Zeiberstein


Leave a Reply

Your email address will not be published.