Baseball Display

Baseball Display

This is a trio of bats designed to hold a baseball.

This model does not have much surface area touching the steel plate, so a brim is recommended. I used a 3mm brim. I was able to print it without supports.

I used full length bat dimensions to model the bats, so it will have to be scaled down in the slicer to print. To print at the right size to hold a ball, I set the X dimension at 2″. From there, Y calculated at 1.8″ and Z at 2″. It can be printed bigger or smaller and still hold a ball, depending on your preferences, so that is just a reference to get it about right.

The photos are from a print with PLA @ 0.10mm layer height and 100% infill.



Rate this 3D model

Download 3D models

File File size
zip baseball-display-model_files 453 KB

Leave a Reply

Your email address will not be published. Required fields are marked *