Vase

Vase

A wavy pencil/pen vase for decorative purposes to hold pens and pencils, or anything else.
It is 111mm tall and 80mm wide.
Print time approximately 1 hour and 50 minutes with a single wall at print speed of 50mm/s.
The photo shows the vase printed in vase mode. It can be printed in normal mode with 0 top layers and 0% infill . The stl file is solid. It prints great in either vase mode or normal.
The photo shows the vase printed in copper by Tecbear.

Print instructions
Nozzle size: 0.4 mm
0.2mm layer height
0.8mm wall line width recommended
50mm/sec print speed
Spiral Vase Mode enabled (spiralize outer contours in Cura)

Credits:

xSteve

Rate this 3D model

Download 3D models

FileFile size
zip vase-715-model_files5 MB

Leave a Reply

Your email address will not be published. Required fields are marked *