– Dino (20200711)
– Set of 3 cacti SOON
Max 2 inch tall
– One cacti SOON
Same hight as the Dino
My design is based on the proportion Andrew Bell gave to his set.
I’m making it in 3D since it’s no longer available for purchased.
NB: I might someday add a simple rectangular plate for each character. Don’t no yet how to connect them non permanently (probably a hole in the bottom of each one and a stick on the plate). I will not copy the exact same plate as Andrew Bell, I don’t like the look.
Print Settings
Printer brand: Monoprice
Printer: Select Mini
Rafts: No
Supports: No
Infill: 10
Filament_brand: amz3d
Filament_color: Green
Filament_material: PLA
Notes:
Took me about 4h04 to print. Can’t remember my setting in Cura (see my Cura Setting section as an exemple. NB: it is my last saved profile, probably was different), but the majority of the print was running at 0.5 speed at the start (stick to the bed) and at the end (better finish). Can’t seem to level the bed correctly and didn’t want to print a rafts (add time). Sorry if the STL file is strange/don’t show up correctly, upload from SketchUp.
Post-Printing
Cura setting
QUALITY – SHELL – INFILL
QUALITY Layer Height : 0.131 Initial Layer Height : 0.2625 Top/Bottom Line Width : 0.35 SHELL Wall thickness : 1.15 Wall line count : 3 Top/Bottom/Initial Layers : 6 Optimize wall printing order : yes INFILL Infill density : 10% Infill pattern : Grid
MATERIAL – SPEED – ADHESION
MATERIAL Printing temperature : 190 C Printing temperature initial layer : 195 Initial printing temperature : 180 Final printing temperature : 175 Build plate temperature : 60 Build plate temperature initial layer : 65 SPEED Printer speed : 30 mm/s Infill speed : same Wall speed : 15 Top/Bottom speed : 12 Travel speed : 40 Initial layer speed : 30 Skirt/Brim speed : 30 Slower Layers : 2 BUILD PLATE ADHESION Type : Skirt Line count : 8 Distance : 2
Credits:
Andrew Bell / Dead Zebra Dino Set