Older versions were less robust and could only run 40-50 cycles in PLA. However, this version is all hinged and runs over 110000 cycles in PLA.
+Nov 24,2020
I made stepv2 to make the motion smoother.
+Dec 3, 2020
Added a shaft that can be printed. For users who do not use 1.75mm filament. Works fine.
Print Settings
Printer: delta
Rafts: Doesn’t Matter
Supports: Yes
Resolution: 0.25
Infill: 20%
Filament: other PLA
How to assemble this
Step 1
Remove the support for all parts. And prepare 3 filaments of 10mm length.
Step 2
Push in the filament.
Step 3
Enjoying!!
Credits:
Gamma4D