Print-in-Place Convertible

Print-in-Place Convertible

This is Print-in-Place design was designed to be printable on any FDM printer. Thanks to the use of bridges and 45° overhangs, this model shouldn’t be too challenging. The design was heavily influenced by the 1958 Chevy Impala. Software used: Autodesk Inventor 2021

The length is roughly 140mm, but when turned 45°, it should fit even onto a 12x12cm buildplate.

3D printing settings
0.2mm layer height
10% infill (or more)

Credits:

budinavit

Rate this 3D model

Download 3D models

FileFile size
rar Convertible_Print-in-Place334 KB

Leave a Reply

Your email address will not be published.