Set of trees and trunks that work interchangeably. The pieces thread together. The set includes 3 trunks and 5 trees:
Trunks
Short Trunk
Tall Trunk
Tall Trunk – Textured
Trees
Spiral Tree
Lattice Tree
Scalloped Tree
Wavy Tree
Diamond Tree
Print Settings
Trunks need no special settings. While the trees do not require any special settings, I recommend the following:
Spiral Tree
25% infill in the base and center threaded area – this adds weight to the bottom and keeps the tree stable after a trunk is added
Manually move seams to the back side of each spiral. This will reduce curling of the leading edge.
Lattice Tree
25% infill in the base and center threaded area – this adds weight to the bottom and keeps the tree stable after a trunk is added
Scalloped Tree
25% infill in the base and center threaded area – this adds weight to the bottom and keeps the tree stable after a trunk is added
0% infill for the rest of the tree
Wavy Tree
25% infill in the base and center threaded area – this adds weight to the bottom and keeps the tree stable after a trunk is added
0% infill for the rest of the tree
Use the Classic perimeter generator – Arachne leaves some unwanted edges
Diamond Tree
25% infill in the base and center threaded area – this adds weight to the bottom and keeps the tree stable after a trunk is added
0% infill for the rest of the tree
The following filaments were used in the pictures above:
Spiral Tree
Bambu Lab Matte Latte Brown PLA
Prusament Simply Green PLA
Lattice Tree
Bambu Lab Matte Latte Brown PLA
Bambu Lab Matte Dark Green PLA
Scalloped Tree
Bambu Lab Matte Latte Brown PLA
Prusament Opal Green PLA
Wavy Tree
Bambu Lab Matte Latte Brown PLA
Inland Lutz Green PLA
Diamond Tree
Bambu Lab Matte Latte Brown PLA
Prusament Mystic Green PLA
Credits:
JamesThePrinter