A simple yet effective container for keeping your zip ties organized and tidy. Designed in Blender.
Print Settings
Printer brand: Bambulabs
Printer: Bambu X1
Rafts: Yes
Supports: Yes
Resolution: 0.4 mm nozzle @ 0.24 mm Draft
Infill: 40%
Filament brand: Generic
Filament color: Black
Filament material: PLA
Notes:
Use tree supports and 1 layer Raft with 0.1 mm Z distance for best results.
Post-Printing
Cleaning up the print
IMPORTANT!
When removing the tree supports, start by twisting the supports at the handle around the corner towards the container. After that, separate the long vertical support right below the handle. Push the support material inwards towards the container before carefully pulling it out.
If done correctly, the vertical seams of handle should not have been exposed to stresses, greatly reducing the risk of it breaking.
Mounting
The holder is designed to hang onto a ledge, originally intended for cable ducts as those are cheap and available pretty much everywhere but it will hold onto basically any sufficiently deep ledge.
Credits:
minki-avali