After having made the Modular Sound Bar / Center Speaker I continued my project of making a full set of speakers using my 3D printer. You could already use the modules of the Sound Bar as stereo and surround speakers, but for my situation I needed the speakers to have a little stand. Once I had done that and hooked everything up I found the high frequencies lacking a bit with the speakers I used so I added a tweeter. This is the result, again fully printable without supports. If you compare the sound bar with this unit you will find that I used different speakers – I have ran out of the units I got from China so I used some (more expensive) store bought (JayCar Australia) ones.
As with the sound bar, please let me know how you go if you end up making these.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Post-Printing
You will have to put everything together using small screws. I used the soldering iron to do all the connections. The tweeter has a 6uF bipolar capacitor connected in series
How I Designed This
Designed using Tinkercad
Credits:
jongdepaul