This is an add-on for your Pokemon Go Plus that you can use to wear it like a ring. I like wearing it on the inside of my hand for easy access to the button on the Go Plus while I’m walking. The interior diameter of the ring is 20mm.
Print Settings
Printer:
PolyPrinter 229
Rafts:
Yes
Supports:
Yes
Resolution:
0.125
Infill:
12.5
Notes:
I printed it upright like the file shows, and the scaffolding was very easy to remove. If you can’t do rafts, it’s probably fine, but I wanted to make sure it stayed very straight. I printed this in ABS.
Credits:
margiemakerspot