Single, Double and Triple Remote Control Caddy

Single, Double and Triple Remote Control Caddy

These models were inspired by the Remote Caddy uploaded to Thingiverse by TheScarfNinja. Others have uploaded single and triple remote versions of that design but they were much larger than I needed.

This design will hold a remote with a maximum width of 60mm and maximum depth of 30mm. The overall depth of the model is only 35mm so it should fit nicely between a bed and nightstand. Each section has a hole for a #8 truss head screw. Two screws per segment would be overkill but should allow for different mounting locations and easy remixing. If you prefer less material usage or quicker print times each model has version with a hexagon patterned side or a solid side. Both versions have the hexagon pattern on the bottom so they don’t fill with debris.



Rate this 3D model

Download 3D models

FileFile size
zip single-double-and-triple-remote-control-caddy-model_files613 KB

Leave a Reply

Your email address will not be published.