The Laptop Saver – A sub-desk level drink holder

The Laptop Saver - A sub-desk level drink holder

Working from home often results in beverages and computer equipment sharing the same desk. This is a perpetually hazardous arrangement (and I speak from experience).

This design is for a cup/drink holder that places the beverage below desk level. This means that mishaps should result in nothing more than getting the floor messy, while keeping the desk, computer, and other important things safe.

It should fit desks from 40mm thick to 8mm thick.

Print instructions

Print the clamp and screw with heavy perimeters and infill for strength. No support required.
If you’re using it for hot drinks, don’t print it from PLA.

Credits:

Martin_au

Rate this 3D model

Leave a Reply

Your email address will not be published.